Install the floor on the mat, and fix the reserved shrinkage joint with the floor pad when the floor is closed. The pad has 3 specifications of 2/2.5/3cm. Choose the size of the floor pad according to the local installation habits. The floor and floor need to be installed tightly, which can be knocked on the floor and then hammered. Both the pad and the knocking board can be found in the installation measuring toolbox.
During the installation process, in order to ensure the smoothness and regularity of the floor, you can use the infrared level instrument installed in the measuring toolbox. The horizontal instrument can output 90 degrees of two lines, and also can align the floor according to the single line. Before use, adjust the flatness of the horizontal instrument according to the double steam bubble preventer.
When the floor is laid to the end, there will be part of the corner space can not be put into the whole floor, this time the need to cut the floor, the floor can be cut where the use of water-based multi-functional sealant waterproof protection treatment, with a brush dipped in sealant evenly brushed in the cutting site, 3-5 minutes to watch dry installation, dry. After drying, it is colorless and does not affect the surface color of the floor.
After the floor is installed, the floor spring sheet is installed in the wall contraction joint. The floor is longitudinally installed with a spring sheet every 40 cm. A spring sheet is installed between the horizontal two floor joint. After the installation, the pad is removed and the installation process is completed.